20
Door reversibility
1. Remove the two screws which fix the upper hinge
to the door.
2. Carefully lean the appliance on its back and remove
the plastic insert.
3. Remove the two screws which fix the lower hinge to
the door.
4. Remove the four screws which fix the lower hinge
to the base of the appliance and remove the hinge
itself; be very careful to recover all the screws.
5. Remove the four screws that fix the upper hinge to
the appliance and remove the hinge itself.
6. Take the hinge removed from the upper part of the
appliance on the opposite side, and, using the
screws removed from the lower part, fix it to the
base of the appliance itself.
7. Remove and refit the other hinge on the upper part
of the appliance on the opposite side. Fix the two
front screws into the upper and lower hinges.
8. Finally, check the alignment of the door and make
sure it closes properly.
9. After having reversed the opening direction of the
door, discard the original plastic insert removed and
fit the insert supplied with the appliance on the
opposite side.
Fitting a decorative door panel
Import ant: The components needed to fit the
decorative panel have been pre-fitted on the
appliance.
The brackets are secured to the panel by means of
the 7 Ø 3.5x13 screws supplied. Before starting to
fit the panel, remove the large top bracket by
unscrewing the screws and adjusting pins pre-
fitted on the appliance door.
The small bottom bracket need not be removed.
1.
Place the appliance in the position where it is to be
built in. The appliance is fitted with adjustable feet;
screw the front and rear feet in or out to adjust the
height of the appliance to that of the recess.
Keeping the appliance central in the recess, slide it
in until its back touches the wall.
Wıth a tape measure (or similar instrument),
measure distance (A) between the top edge of the
door and the top edge of the decorative panel,
placing it next to the recess.
Comentários a estes Manuais