Juno JDL5320W Manual do Utilizador descarregar pdf (Página 2)

obtained in the external exhaust model

(suction), therefore in the limits of the

possibilities it is advised to use the external

exhaust (suction) type.

— The best performances are obtained with

short pipes (max. 4 m) and with few

curves.

Electric connection

Before completing any connection, make

sure the house voltage corresponds with the

voltage indicated on the label affixed inside

the hood.

The hood is supplied with a standard plug;

connect it to a correspondingly standard

socket. In the case is intended to connect the

appliance permanently to the mains after

having removed the plug supplied, must be

fitted a two-pole switch conforming to

regulations with an opening distance

between contacts of not less than 3mm

The manufacturers are not liable for any

problems caused by the user’s failure to

observe the above instructions.

Fixing the hood

After having adjusted the hood for the version

required, it may be installed.

— This appliance is designed for fitting in a

cabinet or some other support.

— the opening to be made on the bottom of

the wall-hung cabinet must correspond

with the measurements shown in fig. 5.

To fix the hood proceed as follows:

a) remove the grill.

b) Fit the hood into the opening.

c) Secure the unit to the cabinet by screwing

up screws through holes C (fig. 5).

d) Replace the grill.

Instructions

Hoods model JDL 5320 is fitted with one

motor.

The power is adjusted by means of a 3-speed

switch.

To get best efficiency, we suggest to use

slow speeds in normal conditions and the

highest in particular cases of strong smell

and vapour concentration.

The switching plate is fitted with two switches

one for continuous adjustment of the

ventilator (top switch) and one for illuminating

the work surface (bottom switch) .

It is advisable to switch on the extractor hood

a few minutes before starting cooking and

then to leave it running for approximately 15

minutes afterwards to ensure that all odours

are extracted.

Maintenance

Before performing any maintenance

operation, disconnect the hood from the

electricity.

Grease filter

The hood has a metal grease filter.

To clean the filter, proceed as follows:

— Open the grill by turning knob A (fig. 3).

— Pull the two plastic stops B as shown by

the arrows (fig. 6) and remove the metal

filter.

— With normal use, the grease filter should

be washed once a month in a dishwasher

or in warm soapy water and should be left

to dry before being refitted.

When cleaning the grease filter, we

recommend washing the grill too with warm

water and soap.

Active carbon filter

The active carbon filter eliminates odours

which are formed during cooking.

If used with normal frequency it should be

replaced once every 4 months.

New active carbon filters are available from

the supplier; it must not be washed.

To remove rotate the filter in anticlockwise

so to unlock it from its seat.

Important

Failure to observe the rules for cleaning the

appliance and changing and cleaning the

filters may cause fires. Therefore, we

recommend observing these instructions.

Changing the bulbs

— Disconnect the hood from the electricity.

— Remove the grate.

— Always replace burn-out bulbs with olive-

shaped max 40 Watt (E14) bulbs.

— Before calling for Repair service because

the hood fails to light up, make sure the

bulbs are screwed in tightly.

Cleaning

To clean the outside of the hood use a cloth

moistened with denatured alcohol or neutral

liquid detergents. Never use products

containing abrasive.

This appliance meets 87/308 EWG radio

and television noise standards.

16 17

1 2 3 4

Comentários a estes Manuais

Sem comentários

Juno JDL5320W Manual do Utilizador Página 2

Comentários a estes Manuais

Manuais e produtos relacionados com não Juno JDL5320W